Air Duct Repair in Reno - Tested First, Written Price Second

Trusted Air Duct Repair for Reno Homeowners

Losing air from your system is the problem air duct repair solves: a joint that has pulled apart, a run crushed under a floor, or a seam that has leaked since the day it was sealed. In Reno’s dry high-desert climate, ducts go through big seasonal swings, and that back-and-forth opens gaps that a mild coastal market never sees. Our technicians have up to 15 years of experience and repair what they find in the same visit instead of handing you a list for another contractor. We’re licensed and insured, and we put one flat price per system in writing before any work starts. Call (866) 361-7643 for a free estimate.

Call (866) 361-7643

HVAC Duct Installation

HVAC Duct Installation is the job of building a new duct system, or a new section of one, to move conditioned air through a home that doesn’t have it yet or has lost it to damage. Homeowners need it after a remodel adds rooms, after an addition gets tied into an undersized trunk, or when a failed section can’t be saved. We design the layout around the furnace or air handler, seal every joint, and check static pressure so the blower isn’t fighting a system built on guesswork. Expect a whole-home install to run roughly $2,500 to $6,500 depending on home size and how much of the run is exposed; a short replacement section usually lands between $450 and $1,200. We carry Abatement Technologies negative-air equipment so demolition dust stays contained during the work.

Planning the Layout

Layout comes before anything gets cut. We look at room volume, register placement and the path with the fewest tight bends, because every elbow costs airflow. A plan on paper keeps a Reno install from turning into a patchwork.

Sealing and Pressure Testing

Once the runs are in, every joint gets sealed, then we test static pressure at the equipment to confirm the system moves the air it should. If it doesn’t, we find the restriction before we leave.

Air Duct Replacement

Air Duct Replacement means pulling out ductwork that has failed and installing new runs in its place, rather than patching it again. That’s the right call when the flex duct has collapsed, when the liner is shedding, or when a previous install left runs that can’t be resealed. We scope which sections actually need replacing and leave the sound ones alone, which keeps the job honest and the cost down. Full replacement typically falls in the $2,500 to $6,500 range for a house, while a single trunk-line swap runs around $450 to $1,200. Our technicians have up to 15 years of experience reading duct condition, and we’ll show you photos before we quote a replacement.

When Patch Work Stops Working

Repeated seam failures usually mean the material itself is done, not the seal. Once the substrate is degrading, patching is money spent twice. Replacement ends the cycle.

Matching New Runs to the Old System

New duct has to move the same volume the equipment was sized for. We measure the existing trunk and the register counts, then match the replacement so the system stays balanced.

Ductwork Repair

Ductwork Repair covers the fixes that restore a leaking or disconnected run without replacing it: resealing joints, reconnecting plenums, rehanging sagging flex, and patching holes where pests or trades have cut through. It’s what you need when the system still runs but rooms won’t heat or cool, when your energy bill has crept up, or when you can feel air moving behind a wall. Most repairs in Reno run $180 to $550 depending on how many connections and how accessible the runs are. We do this in-scope on the same visit, then clean with Rotobrush and Nikro HEPA extraction so disturbed debris leaves with us. Spots like Spanish Springs and Washoe Valley see big temperature swings that stress joints; we work both.

Finding the Leaks

We walk the runs, check every connection, and look at the plenum and register boots. Leaks hide at the joints nobody thinks to check. Finding them first is what makes a repair stick.

Sealing for the Long Run

A repair is only as good as the seal. We use mastic and proper tape rated for the job, not the wrong tape that peel-and-stick leaves behind. Then we verify airflow.

Duct Replacement

Duct Replacement is a targeted job: replacing a specific failed section, branch or trunk line without tearing out the whole system. It’s the practical answer when one run has to come out, such as a line crushed during renovation or a flex run that has flattened to a fraction of its diameter. We isolate the section, install new duct matched to the system, seal it and test airflow again. A single-section replacement usually runs $450 to $1,200; larger trunk work goes up from there. Homeowners in Cold Springs and Golden Valley often get this done alongside a cleaning, since a fresh run should go in clean. Here’s exactly what happens: we scope, quote, and the written estimate sets the final price.

One Section, Not the Whole House

Most homes don’t need everything replaced. Isolating the bad run saves the rest of the system and keeps the invoice proportionate. We tell you which is which.

Protecting the Rest of the System

When we open a duct, dust has somewhere to go. Negative-air containment keeps debris out of the living space while the new section goes in. That’s how we protect the rooms you live in.

Ductwork Installation

Ductwork Installation is the fitting and connecting of new duct components into a home: registers, boots, transitions, and the runs that feed new living space. It’s needed on additions, finished basements, garage conversions, and any room a previous installer left without a proper supply. We size each run to the room, set the boot clean and straight, and seal it so the air goes where the thermostat thinks it does. A small room addition is usually $600 to $1,500; a larger multi-room installation climbs toward the whole-home figure. We work in Mogul, Verdi and Sun Valley, where homes often have additions the original duct layout never accounted for. Whole-home indoor air quality depends on every run doing its part.

Sizing New Runs Correctly

A new supply run has to feed the room without starving the rest of the system. We calculate the volume the room needs and size the duct to it. Undersized runs are the most common installation mistake.

Connecting to Honeywell and Aprilaire Systems

When a home has a whole-home filtration or humidity system, the new ductwork has to tie into it correctly. We know how Honeywell and Aprilaire setups connect to duct runs, so the air quality equipment keeps working as designed.

Brands We Service

We work with Honeywell and Aprilaire whole-home air quality systems and understand how ductwork links to filtration and humidity control, not just the runs in isolation. A Honeywell system relies on correct duct flow to do its job, and we check that the connection is right rather than treating the duct as a separate concern. Abatement Technologies is the equipment class we use for containment during repair, which is the same grade trusted in commercial remediation.

Guardsman-grade protective treatment is available after cleaning, adding a defensive layer once the ducts are repaired and clear. Whether you have Honeywell or any other make, we can help.

Signs You Need a Pro Right Now

• Rooms that never get comfortable. One room stays cold or warm while the rest of the house is fine. That’s usually a disconnected or crushed run, and it gets worse the longer it runs.
• Air moving behind walls or from the ceiling. Feeling a draft from a wall or ceiling that has no register in it means a joint has failed in the supply trunk.
• A rising energy bill without a change in habits. Escaping air means the equipment runs longer to hit the setpoint. Unchecked leaks keep costing you every month.
• Whistling or loud rushing at registers. That noise usually means a restriction or an undersized run, not just strong airflow. It’s a sign the system is working harder than it should.
• Visible dust trails around registers or drifting dust after cleaning. Seams drawing in unfiltered air pull dust through. If it comes back after a clean, a leak is the source.

Our Process, Step by Step

1. 1
   Inspection and diagnosis. We walk the system, check the plenum, trunk and every branch, and note where air is being lost. We photograph the problem before anyone quotes a fix, so the findings match what you can see.
2. 2
   Written scope and one flat price. You get a written estimate that sets the final price per system before work starts. No per-vent pricing, no teaser number that grows once a technician is on site.
3. 3
   Containment and repair. We set up Abatement Technologies negative-air containment so dust stays out of your rooms, then make the repair. Rotobrush mechanical agitation and Nikro HEPA-rated extraction follow, capturing particles down to 0.3 microns.
4. 4
   Verification and photos. After the repair we recheck airflow and joints, and we show you before-and-after photos of your own ducts. You see what was done.
5. 5
   Protective treatment and sign-off. If you want it, Guardsman-grade protective treatment adds a defensive layer that outlasts the day of service. Then we walk you through what we found and what we fixed.

How Much Does Air Duct Repair Cost in Reno?

Our Service Area Near Reno

We serve homeowners across the Reno area, including Sun Valley, Lemmon Valley, Cold Springs, Spanish Springs, Washoe Valley, Incline Village, Mogul, Golden Valley and Verdi. Crews are dispatched Sunday through Friday, from 7am to 7pm, with fast dispatch across the valley. If you’re booking duct cleaning Reno work as well, we can fold it into the same visit. Homes near the lake at Incline Village and the higher ground around Verdi often see sharper seasonal swings that stress duct joints. Call and we’ll confirm the time for your area.

Frequently Asked Questions About Air Duct Repair in Reno

Schedule Your Air Duct Repair Service in Reno Today

If your ducts are leaking, disconnected or crushed, we’ll find the source, fix it in the same visit, and give you one flat price per system before work starts. Our technicians have up to 15 years of experience and show before-and-after photos of your own ducts. Call (866) 361-7643. We answer 24/7. Fast dispatch from 7am to 7pm, Sunday through Friday. Estimates are free and there’s no obligation.

Written by the team at Duct Cleaning Reno.